Specifications Working Pressure Temperature Body Material Packing Material Manifold Connections Configurations

Up to 6000 psig (413 bar) Up to 400°F (204°C) 316 stainless steel (CF8M/ASTM A351) PTFE 1/4 in. ISO parallel thread (G1/4); optional Swagelok tube fittings installed 2- and 4-valve pressure and differential pressure manifolds; instrument monoflanges for isolation and vent functions; self-venting single and double purge blocks

• Metal-to-metal seals and parallel threads in accordance with BS 2779 (ISO 228/1)
• Instrument mounting face in accordance with DIN 19213
• Allows pre-assembly that can reduce field installation time and cost
• Hydrostatic test certificates complete with full chemical and physical material certifications available

Two-Valve Pressure Manifold

• One isolating and one venting valve for absolute and gauge pressure transmitters

Two-Valve Differential-Pressure Manifold

• One isolating and one venting valve for low-pressure applications and level measure on atmospheric tanks with differential pressure cell

Pressure Manifold

• One isolating and one venting valve for direct connecting to pressure transmitters or pressure gauges and mounting plates
• Integral gauge adapter, 1/2 in. NPT for 360° position, 1/2 in. ISO parallel thread (G1/2) option

Instrument Monoflange Gauge Block

• One isolating and one venting valve suitable for direct connection to horizontal and vertical pipes.
• 1/2 in. ASME B16.5 flange
• Low- and high-pressure versions

• Self-venting single purge block for pressure measurement and differential pressure measurement.
• Self-venting double purge block suitable for differential pressure measurement and for connecting to instrument impulse lines on 2 1/8 in. (54 mm) centers

• Seal pot with integral vent valve
• Electric heater block for use where heating of manifolds and instrument bodies is required for winterization
• Steam tracing block for use where heating of transmitter bodies and manifold is required
• Filling connector with integral, soft-seated nonreturn valve
• Mounting plate assemblies (type A and B) allow mounting of manifold, connection box, or air filter/regulator, nameplate, and protection shade
• Port protector with integral 750 µm filter screen
• Purge orifice nipple with restricted orifice and data tag plate
• Manifold kidney flange blank for protecting process lines when removing the differential pressure instrument
• Protective shade for extra protection of electronic instruments against environmental conditions
• Antitamper key fits all vent and equalizing valves within the system

Seal Pot with Integral Vent Valve	Filling Connector with Integral Nonreturn Valve	Protective Shade